Betta is a stunning tropical fish, and it is suitable for breeding in a small aquarium. It is one of the tropical fish with the lowest breeding hurdle because the initial investment is low, and it does not take up space.
In addition, the beauty of the individual is often emphasized, and although it basically breeds alone, it is a very deep aquarium. However, solids have a rough temper and are bred alone. If you want to breed betta fish, you need to be creative, so be careful and read this guide from top to bottom.
Things to Prepare for Betta Breeding:
Aquarium:
Betta is often bred in bottles or small aquariums. However, breeding does not work well with small bottles, so you need to prepare a separate aquarium. The amount of water is at least 5L. It is recommended a wide aquarium because it can be shallow to some extent.
Whatever; It’s best to have a lid to prevent the escaping scalpel from jumping out. For those who want to focus only on breeding, we recommend a container for raising insects. Some solid farms also used containers.
Heater:
Heaters are essential when breeding solids in the US. Often the water temperature is to trigger breeding because the hatching of the eggs is also being affected by the temperature, and can be adjusted to a set temperature thermos recommended.
Summary of betta fish breeding methods:
Betta breeding is so intense that it may look like a male is bullying a female. In most cases, the female fins will be ragged. But, this is solid breeding. However, they may not be compatible with each other, so it is important to carefully observe the progress after inserting the female, such as whether the male and female are incompatible.
And if it doesn’t lay eggs after three days or if the female is too badly injured, take the female out and let it rest. In this case, it may be better to insert another scalpel if possible.
Eggs laid in the bubble nest sink one after another. The male works hard to pick it up by mouth and put it back in the foam nest. I will continue this forever. Eggs hatch in about two days, but larvae can’t swim and fall after all, so males pick them up again with their mouths and put them back in the foam nest.
When a betta cub becomes a fry that can swim freely, it will start eating small microorganisms in the aquarium, but this is not enough, so hatch the brine shrimp eggs in saltwater for a day. Dilute this with fresh water twice in the morning and evening. The betta fish will grow bigger and bigger.
The males will continue to protect the fry for the next few weeks, but when the fry are free to feed, take them out and let them rest. When males and females became known to be solid pups, males had to be bred separately.
In other words, it is necessary to place dozens of small containers in a place where you can maintain the temperature at 20 degrees or higher all year round. Then, it is safe to take on the challenge of solid breeding after carefully checking whether such an environment can be prepared so that you will not be in trouble later.