LED Bulbs :
Introduction
LED lights are bright and can add to the amazing decor of your room or space. They come in many forms, like strips, bulbs, rods, and many more. In this article, we will talk about the strips and the bulbs. At this time, the LED market is rising. The best high bay led lights are very helpful as they provide you with a very bright amount of light and save energy too. You should be aware that why are you switching to LED lights. The reason behind this is that they are more energy-efficient and that is why they last much longer and provide a lot of lighting options on Lepro.
Concept of LED light bulbs that are important to understand –
The three important concepts are –
- Brightness –
Wattage doesn’t define the brightness when you are using the LED bulbs. This happens because the LED lights consume less power. You shouldn’t compare the brightness of the incandescent bulbs and the LED bulbs based on what the wattage is being used. You should pay attention to the Lumens. It helps in defining that how much light a particular product emits.
- Light Appearance –
The colour temperature of the light is measured in kelvin (K). The kelvin number must be looked at when you want to know if the light is warmer or lighter. If the number is less, then the light is warm and higher the number, the light is cool. Most people say that the cool part is not good.
- Colour rendering –
There is a difference between the light sources in the matter of their ability to show the correct colour of the objects. The correct here means that when it is compared to the natural light source. A good CRI is considered to be above 80 and is sufficient for most of the applications.
Installation –
You don’t need to rewire your house to use the LED bulbs. The commonly used lightings can be good enough for using the LED bulbs. There is a built-in transformer in most of the LED fixtures. They can be easily connected to a standard outlet. When you are getting these bulbs installed, it is advisable that you let the licensed electrician perform such installation tasks if there is a requirement for electrical connections to the voltage line.
LED Strips :
When you want to install the LED strips, they are ready-to-stick on ones that are easily available at electronic stores. They can be a bit pricey and cannot be wired together. You can put them anywhere. The only thing that is difficult to figure out is that you have to decide the components that are required.
How to Install LED Strip Lights?
Step 1 –
Firstly determine the length that’s required and cut the strip through the copper contacts only. To maintain the connection, you need to cut it right on that line.
Step 2 –
The next step is to connect the cable. Using a solderless clamp, connect the wires to the strip. The strip then needs to be pushed into the short end of the clamp. Then you need to match the coloured wire corresponding to its letter on the LED strip present at the other end of the clamp. The order might not be the same so some rearranging would have to be done. You don’t need to strip the wires. You can just pinch the clamp tight.
Step 3 –
Now the 3rd step is to attach the controller. It is important as it gives you the ability to change the colour of lights or dim them. Now you have to strip the coloured wires. Now they would have to be aligned with the corresponding port present in the controller. Then tighten the screws to clamp them into their place.
Step 4 –
Now you will have to mount the lights. You can put them anywhere you want by peeling away the adhesive backing and sticking them in the desired place. You can use the aluminium channel if the lights are hidden completely. The channel accommodates different sizes of LED strips. They have a frosted lens that gives a finished look.
Step 5 –
The last step is to power the lights. If you are adding them to a 12-volt system, the positive and negative 12-volt leads would have to be connected to the controller. If they are being added to your home, the transformer has to be plugged into the controller and then the transformer into the outlet.
Conclusion –
We have reached the end of the article and we hope that you have understood the guide on how to set up the LED lights in your home.